CMT-CHUTE
 Add on to your existing
trailers with two simple assemblies!
The mounting
assembly stays with each trailer.
The chute
assembly can move between trailers
Order a
mounting assembly for every trailer in your fleet.
Add
Chute assemblies as your demand increases... |
A full 180-degree swing is
perfect! |
   |
|
A simple slide-on, slide-off
installation! |
At only 40 pounds this
non-stick plastic makes clean up and transport easy! |
Two Simple Assemblies |
1. Mounting Assembly |
1. Chute Assembly |
 2.
Slide the mounting assembly over the rear tilt frame support
and center on the drum opening. |
 2.
Slide the square tube opening over the round pivot bar on
the chute and pin into place. |
 3.
Insert the tube spacer behind the frame and push the bolt
from the bottom. Tighten with washers and nut. |
 3.
The Chute assembly slides on and off the square tune of the
mounting assembly. Align and pin together. |
      |
